… If you build it, they will come.

I am OB-SESSED with this super simple #DIY coffee table from A Beautiful Mess.

This project is great for someone with little wood working experience (and I’m not carpenter).

Here’s what you’ll need:

Supplies:
-(9) 55x2x4 inch boards
-(12) 8.5x2x4 inch boards
-(2) 13.5x2x4 inch boards
-(2) bench style hairpin legs, or 4 wooden legs (I used these)
-2.5 inch wood screws (I bought a box of 50 and used about half)
-sandpaper
-Polycrylic protective finish in semi gloss

Tools:
-power saw
-power drill
-paint brush for stain
-saw horses (optional)

First cut your 2×4 boards to the sizes listed above. Set the boards up as they will be for the final look, and mark where the legs will go to ensure space.

NOTE: If you wanted to remove power tools from the equation altogether, I bet this project could be pulled off pretty easily if you just got all your pieces of wood cut to 55 inches and simply wood glued the whole thing together. We wanted our legs to sit inside the table and wanted it to weigh a little less, so we went with a more hollow center. Either way, just throwing that out there.

Cut the boards to the size you needSecond, lay out the top layer of boards (consisting of five of the 55x2x4 boards). Keep in mind that this will be the top of your coffee table, so pick the prettiest sides. We offset every other board 2.5 inches to get that bundle of 2x4s look.

The only kind of tricky part to this table is finding the best method to hold the boards together horizontally. We opted to use a couple cross beams and hide them with the second row of 2x4s. So lay out your second row of 55x2x4s on either edge (be sure to stagger 2.5 inches). Grab your 13.5x2x4s  and use them as a guide to figure out where you’ll need to put the notches. Go ahead and lay out your smaller 8.5x2x4s on the vertical edges for that row as well just to make sure they fit.

Mark the edges on your second row of 55x2x4s, so you know where to cut, and give yourself some extra room. This part will be totally hidden anyway. We used our circular saw to cut the notches, but it can be done with a jigsaw or even a handsaw + chisel. A quick google search can show you the best notching techniques based on the tools you have available. Again, it’s gonna be totally hidden, so no big deal if it’s a little/lot sloppy.  Once cut, drill your second row and crossbeams into place.

Screw the boards togetherNext, layer by layer, screw all the boards in place. This is where you can add a staggered, stair step look to the edge if you want. Like I said, ours is offset 2.5 inches. Once you have all the boards in place, screw the legs on as well.

Seal the tableLast you’ll want to sand the entire surface and edges well. 2x4s aren’t always the smoothest. Then seal with a few layers of semi-gloss polyurethane. We chose not to stain the wood as we wanted to keep the light, raw wood color. But if you want to stain before sealing—go for it. I’m not going to stop you. It all depends on what will look best in your space.